Introduction
We built this infrared carbon heating lamp for the industrial jobs that demand serious, focused heat—right where you need it, in a compact footprint. It’s a halogen-style infrared heater, made to deliver raw power and get you to temperature fast, with control that’s actually precise. If your setup needs a lamp that’s tough, quick to wire, and ready for non-stop duty, this one was built to pull that weight.
What It’s Really About
Here’s the core of it: 400V, 2500W, all packed into a 300mm tube. That’s not just numbers on a spec sheet. It means serious heat in a small space. The 400V design keeps the current lower, so your wiring stays simpler and cleaner—less strain, easier sizing. And that 300mm length? It concentrates the heat zone, so you get intense energy density without needing a bigger machine footprint.
The Build, Inside and Out
The tube is quartz. Why? Because it stays rock-solid at high temperatures and lets infrared energy pass through cleanly. Inside, the carbon filament runs hot enough to pump out shortwave infrared. That heat gets absorbed fast by a lot of materials—so you’re not wasting time warming up air, you’re heating what matters. A halogen gas fill helps keep the filament stable, which means more consistent output over time. And the coating isn’t just for looks—it shapes the heat pattern and shields the tube from whatever the environment throws at it. Then there’s the R7s connector. It’s practical, industrial, and it does the job: a secure two-point end-cap connection that stays tight even with repeated swaps and vibration. So when you need to change a lamp, it’s quick—less downtime, more uptime.
Where It Shines
This lamp shines when fast response matters—think plastic processing, coating drying, curing components. Shortwave infrared hits surfaces directly, so you skip a lot of the wait time you’d get with convection heating. And because it’s compact, it slips into tight spots without forcing you to redesign the whole machine. But let’s be real: packing 2500W into a short tube means serious local heat. Your machine has to be ready for that. Proper reflectors, airflow, and clearance are non-negotiable—for protecting your equipment and keeping everyone safe.
The Bottom Line
We engineered this to drop straight into standard R7s-fitted systems. You get high power, stable output, and an installation method your maintenance team already knows. No hassle, no learning curve—just a lamp that shows up, does the work, and keeps going.