efficient infrared carbon fiber heating panels

efficient infrared carbon fiber heating panels

Introduction

We built these infrared carbon fiber heating panels for engineers who need serious heat—fast—without giving up precious floor space. At the heart of it is a quartz tube with a carbon fiber filament, paired with halogen tech to keep the output steady. The whole point? Get your part hot, fast. Keep the temperature locked in. And make the lamp a breeze to wire up and swap out when you need to.

Technical Deep-Dive

These panels run on 400V and pack 2500W of power into a 300mm length. That’s not by accident. High voltage means lower current for the same wattage. So you can use smaller conductors and lose less power over distance. And that short 300mm footprint? It concentrates all that heat into a tight spot, giving you serious watt density in a small package. Perfect when your machine space is tight but the thermal demand is huge.

Material & Design

The quartz envelope can handle extreme heat, keeping the carbon fiber filament in a stable environment. Halogen gas fill keeps the filament clean at high temps, so output stays consistent over time and you get less blackening. The coating is built for high emissivity in the infrared range, which means more energy goes right into your target, and less gets wasted into the air. And the R7s connector? It’s a straight-through, two-pin setup. So the lamp drops right in where you need it—no hassle.

Application & Benefits

Use these lamps wherever you need rapid, focused heating: PET blowing, thermoforming, drying, curing lines. The heat density is high, so you’ll hit setpoints quickly. But that also means your cooling and guarding need to be properly spec’d. These lamps are tough—they can take a beating—but they still need solid airflow and over-temperature protection. Bottom line: you get a compact, high-output heat source that installs fast and holds steady where repeatability matters.